no thanks, mine are fine.........but thanks for offering!!
how do i replace a throttle cable on a 1988 ford ranger pickup
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
The speakers in the doors of a 1991 Ford Ranger are 6-inch speakers.
diagram of fusebox on 1988 ford ranger
i need help with the temp.gage in a 1988 ford ranger
How do you replace a 2003 Ford Ranger radio
i have a 2001 ranger xlt and my door speakers are 6 X 8
10W30 is the type of oil that a 1988 Ford Ranger takes. The Ford Ranger was first produced in 1983 and discontinued in 2012.
how to replace water pump on 2001 ford ranger
replace the heater core if that's not it start checking fuse
how to replace u-joints on 1995 ford ranger 2wd
The speakers are probably 6" X 8".
fordparts.com shows disc brakes on the front of a 1988 Ford Ranger
how do i replace front wheel bearinbs on 2000 ford ranger 4wd
Yes you can. I replace my factory speakers on my 1998 Ford Expedition with Pioneers.
I'm not a mechanic / technician but on a 1988 Ford Ranger there might be ( 1 ) oxygen sensor ( upstream sensor )
how do you replace a turn signal flasher on a 1999 ford ranger pickup
Depending on what year model 1990-1999 is either 6x8 (5x7 is the same thing) or 6.5". The 1996 Ford Ranger XLT model the front and rear speakers are 6x8(5x7).
how do i take the fan cluch off a 89 ford ranger yo replace
where is fuel filter located on a 1992 ford ranger
how do you change motor mount on 2002 ford ranger
I believe the 2.9 liter V6 engine in a 1988 Ford Ranger is rated at : ( 140 horsepower )
if it is a extended cab all 4 four speakers are 6X8
How do you set the timing on an 1988 ford ranger 4 cylinder
where to set timing for a 1988 ford ranger 2.2l
open your trunk and you will see the speakers take the screw out and pull your speakers out
The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.
Yes , there was a 2.9 litre V6 engine available in a 1988 Ford Ranger , as well as the 2.0 and 2.3 litre four cylinder engines
how to replace a blend door actuator on a 1999 ford ranger
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
how to replace oil pump in a 1999 ford ranger xlt ext cab 4.0
How do I remove air from the cooling system of a 95 ford ranger 4 cyl
6X8 most speakers are 6X9, pioneer makes a factory replacement for Ford/Mazda that is 6X8
1996 ranger does not have speedo cable it is electronic
The stock speakers in a Festiva are 4 inch all around
I'm pretty sure they're all 5x7s
You can use 5x7 or 6x9
I believe they are swithable if the ranger had the 2.9 V-6. (same mounts)
The external fuel pump of an 1988 ford ranger 4*4 xlt is located inside the fuel tank or gas tank.
The door speakers are 5.25 inches but you have to purchase an insert in order to replace the door speakers.
Replace every 60,000 miles. need picture diagram of 2.3 4cyl ford ranger 93 timing belt diagram
According to one of Fords websites : For a 1988 Ford Ranger : ( the Motorcraft FL-1-A engine oil filter is used for the 2.0 , 2.3 , and 2.9 engines )
Pull them out and replace them one at a time.
what sort of cylinder you want to replace?
Go to Auto Zone or any type auto parts supplier, buy the blades and they usually put them on at no charge
it is hard to replace the speaker because the ford explorer needs accessories manufactured by the same manufacturer
before it breaks and you get stranded
Use A Ford Ranger Repair Manual (1983-1992) And It Will Tell You What To Do And Give You Specific Pictures.
replace lower ball joint on ford ranger 2001