0
How do you replace a broken throttle cable on a 1988 Ford Ranger?
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What causes gas pedal to stick while driving a 1996 Ford Ranger?
Take it to a mechanic ASAP. This is very dangerous. a cause of is the throttle cable fraying replace the throttle cable.
How do you replace throttle cable on grizzly 600?
how to replace throttle cable on grizzly 600
How do you replace the throttle cable in your ford ranger 2001?
go to autozone.com and look at the online repair manual they have and it will tell you step by step
My Kawasaki 636 will not rev?
broken throttle cable.
How do you replace a speedometer cable in a 1996 Honda civic?
There is not speedometer cable on a 1996 Honda Civic. There is a throttle cable. Top replace this unhook it from the throttle body and gas pedal. Hook on the new cable to snake it through the firewall. Properly hook the throttle cable to the gas pedal and throttle body.
How do you replace the speedometer cable on a 1996 ford ranger?
1996 ranger does not have speedo cable it is electronic
Where is the idle adjustment on a 1984 ford ranger?
There should be a screw near the end of the throttle cable on the throttle body.
How do i replace a speedometer cable on a 1988 ford ranger 4wd with a 2.9 engine?
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
Car idles but doesn't rev?
Broken/disconnected throttle cable
Dodge ram 2001 1500 throttle stuck even in neutral?
replace the throttle cable.
Why are you not getting any throttle response when you step on the gas peddle of your 1991 mercury capri?
The throttle cable may be broken.
Why does Throttle stick on 1997 Honda Passport?
I had a stuck throttle on my 1996 Passport. The throttle cable had a piece of protective black rubber around the throttle cable between the outer cable covering and where the cable connects to the throttle body. The rubber had began to come apart and some of it was getting inside the throttle cable covering, causing the throttle cable to bind. I removed the rubber piece and cleaned out the cable by covering it with GOOF-OFF and then sliding the cable in and out until my cleaning rag was clean when I wiped off the cable. I did not replace the rubber piece and have had no problems since.
