0
To replace the throttle cable on a 1989 Ford Bronco, first disconnect the negative battery cable for safety. Remove the old throttle cable by detaching it from the throttle body and the accelerator pedal assembly. Install the new throttle cable by connecting it to the throttle body and fastening it to the accelerator pedal. Finally, adjust the cable for proper tension and reattach the battery cable before testing the throttle operation.
What else can I help you with?
How to replace clutch 1989 Acura Legend?
In order to replace a clutch on 1989 Acura Legend, you would have to remove the old one. You will do this by removing the jam nut that holds the pedal and disconnecting it from the throttle cable and replace it with a new one.Ê
How do you replace a transmission cable for a 1989 eagle premier?
There are two cables. One is the Throttle valve (TV) cable and that should go from the throttle linkage to the transmission. It will pop off the throttle arm and there is one bolt holding the cable housing to the transmission. take it out the bolt and unhook the linkage and replace the cable making sure to snap it back on at the throttle arm. The other cable is the for shifting and it should attach to a lever arm on the side of your transmission and go to the shifter linkage. If you are under the car and have someone shift with the car off you will see the the arm moving disconnect it from both ends of the cable and replace.
How to Replace speedometer cable 1989 Toyota truck?
Speedometer cable replace 1989 toyota
How do you change a throttle cable on a 1989 Honda Accord LX?
please tell me
How do you adjust the throttle valve cable on 1989 suburban with 5.7 V8?
To adjust the throttle valve cable on a 1989 Suburban with a 5.7 V8, first, locate the cable where it connects to the throttle body. You can adjust the tension by loosening the adjustment nut or bolt and sliding the cable housing to achieve the desired tension. Ensure that there is slight slack when the throttle is closed, which allows for proper operation. After adjustment, recheck the throttle response to ensure it's functioning smoothly.
How do you replace starter on a full size 1989 Ford Bronco?
remove batt. cable from starter(its not wired to batt so has no power) remove 2 1/2 bolts remove starter
How do you replace alternator ford bronco ii 1989?
To replace the alternator in a 1989 Ford Bronco II, start by disconnecting the negative battery cable to ensure safety. Then, remove the serpentine belt by loosening the tensioner. Next, disconnect the wiring harness from the alternator and unbolt it from the engine. Install the new alternator by reversing the removal steps, ensuring all connections are secure before reconnecting the battery.
How do you fix a sticky throttle on a 1989 Dodge Dakota 3.9L V6?
1st check throttle housing,then if it is the cable getting stuck you can oil it a little bit
If a 1989 ford bronco II does not react to the gas paddle what is wrong?
The throttle linkage is likely disconnected at the throttle body. Its under a plastic cover and cant be seen until removed. It clips on and comes off easily
Diagram of a 1989 Bronco II Fuse Box?
list of fuses for 1989 bronco 2
How much does it cost replace an exhaust system on a 1989 Ford Bronco XLT?
$ 300 magnaflo sounds same as stock
How do you replace a throttle position sensor on a 1989 cutlass ciera?
Unplug the wire on the side,remove the screw on it,,pull it off and replace with new one.
