Jack up the front of the car and support it on jack-stands. Remove the wheel and tire. Support the bottom of the axle stub and lower control arm with a jack. Remove the clip holding the brake line to the strut and slide the brake hose out of the tab on the strut body. Remove the two pinch bolts holding the strut to the hub carrier. Raise the hood, and remove the two bolts holding the strut to the top of the inner fender. Slowly drop the hub carrier assembly, steadying the strut so that it doesn
Take the strut from the left and use this
there is a fatty that comes and does it
You will need to compress the 2002 Pontiac Grand Am strut spring with a spring compressor. Remove the top and bottom strut retaining bolts. Reverse the process to install the new strut.
Drivers side between the fuse box and strut tower.
To replace the strut you have to jack up the car on the side you want to do and take off the wheel. Then, take it loose from the strut tower on the top. There are 3 or 4 nuts. Then take it loose from the steering knuckle on the bottom. The whole strut assembly lifts out. To replace the coil you have to have a strut compressor. It compresses the coil spring so the top of the strut can come off. Once the top of the strut is exposed the coil can be taken off the strut.
The fuse box is located under the dash on the drivers side of the car.There is also a fuse box under the hood by the drivers side strut tower.
on the drivers side right in front of the strut conector there is a black box open it if you are facing it from the drivers side fender it is the secent relay on the left
on passenger side between firewall and engine, It has an "L" on cap if not there it should be by the drivers side strut!!
Left (drivers side) strut tower, bolted to the top
Mounted to the drivers side strut tower.
On the back side of the drivers strut tower....big silver box with a blue relay on the side.
What about the sun visor...the answer didn't say anything about how to remove and replace the visor
on drivers side by strut tower, under cover.
you will need to rent a strut spring compressor tool from your local auto parts store, first locate the top of your strut on the inside of your trunk, there should be three nuts located at the top of the strut..one on the strut itself and two on each side...second pull the tire off the side that your working... third compress the strut spring with the tool, then with a adjustable wrench hold the top of your strut, while unscrewing the nut on top with a (13mm or 14mm ) wrench...forth locate the bolt on the bottom of the strut remove it(16mm or 17mm)and the strut will come down....remove the old strut and replace with new one...re-install
Drivers side fender well above the strut. Small black box.
more than likely you will have to replace the drivers side master switch
Under the hood. Drivers side. In a box above the wheel opening, under a support strut.
THE ONE OF THE TWO ON THE STRUT TOWER CLOSET TO THE ENGINE. THE ONE OF THE TWO ON THE STRUT TOWER CLOSER TO THE ENGINE.
there are two fuse blocks, one on the drivers side of the dash, and the other under the hood, near the left strut. Actually, there are 3. One is on the drivers side of the dash, the other under the hood, and the third on the passenger side of the dash.
If you are asking about the location of the radiator reservoir it is on the inner fender well next to the strut tower on the passenger side. If you are asking about the windshield washer reservoir it is between the battery and the strut tower on the drivers side of the car.
how do i replace the drivers side headlight in a 2003 oldsmobile silhoutte
how do i replace drivers side mirror Nissan maxima 2005
audi a3 how much replace drivers side window
Remove the inside door panel of your Chevy Cavalier. Remove the drivers side mirror wiring harness, if the mirror is electric. Remove the drivers side mirror retaining bolts. Reverse the process to install the new drivers side mirror.