Changing a tail light on the Passport/Rodeo isn't really as difficult as I have seen some people make it out to be. I have a 2000 Passport, so I'm assuming that most other years for the Passport/Rodeo are similar. To change the bulb you have to remove the rear light fixture. You DO NOT have to remove anything on the interior of the vehicle. There are three screws to get the fixture off. The first two are on the side of the fixture in the small recesses that look like vents in the lights. They are diffuclt to see, but if you look closely, they're right there. Take them out. The third screw is located on the rear of the car, between the bumper and the fixture. It's hard to see without a flashlight. Loosen the screw until it turns very easily and gently pull back and up on the fixture. The assembly should slide right out. There is a pressure fit plastic piece that lines up the fixture. Be careful not to snap it like I did. After that, it's easy. Remove the snap fit electrical supply to the fixture and you're home free. Change the bulb and you're done. Getting that bottom third screw back in can be tricky. I found it easiest to put the screw back in and cover it with a thin piece of tape to hold it in place. Once the fixture is lined up you can secure the sides and screw the bottom in by puncturing the tape with the screwdriver. Took me an hour to figure it out the first time, took five minutes the next.
How do you replace the rear brake light bulb on a 2001 Honda civic?"
How to replace passenger side head light bulbs in a 2000 Honda Accord?
There was a recall for all Passports concerning this issue, it was a sensor that loses calibration, Honda dealership will update ECM (car computer) with new algorithim.
y want to replase the bolb from tail light for Honda odysey 1999
where are the bolts?
My ABS light was coming on too and I found out it was my ABS control module, which isn't cheap. I found out this is a common problem in 1998 Honda passports.
Look inside the trunk under the light for bolts to remove the light.
dash light location on a 1999 hound accord V6
To replace a taillight on a 1996 Honda Civic prop open the trunk. Remove the twilight mounting hardware. Push the light outward. The unit should come off in one piece. Replace the taillight with a unit that fits.
To replace the light, it all depends on the year of the Accord. I have a 5th gen(94-97), and I know how to replace the 4th gen(90-93)
Take it to the garage
you take it apart and fix it
It's the transmission computer.you need to replace it.
If a turn signal does not blink on a 1996 Honda Accord that it is time for it to be changed. To change the bulb and locate the light housing and remove the older light. Replace the light.
Remove your 1998 Honda rear window brake light cover. Push the light bald in and turn at the same time. The light bulb will come out. Reverse the process to install the new light bulb.
replace your speed sensor
Replace your AT Control Unit (Automatic Transmission Computer)
To change the brake light bulb on a 1999 Honda Passport find the light housing located in the trunk. Find the plastic covers for the lights and remove them. Pull the bulbs out carefully and replace them.
Original equipment part for brake light replacement on 2000 Honda Odyssey EX is: 7443 W21/5W STANLEY 12V 03U E4 2DW
Your light hasn't burned out. It's not coming on because you have a full tank.
From inside the trunk behind carpet/liner.
Adjust or replace the brake light switch.
get a new light bulb ,take the cover off the light bulb that's broken and replace it.
Buy Sylvania Bulbs, 7443 type 12 volt