Remove the taillight assembly to gain access to the bulbs
how to change a taillight in a 2008 Nissan maxima
how do you replace a taillight on a Honda 2002 Civic?
I believe you have to unscrew a couple bolts on the inside of the truck bed to get the taillight assembly off the truck then you can unscrew the light sockets and replace the burnt out bulb
It cost me less than $3 if you talking about the bulb...not sure about the cover too
unscrew it and screw in the new bulb
There are two bolts inside of bed unbolt to remove taillight. Remove bulb, push down slightly and turn. Replace with new and reassemble.
there are two screws or bolts that hold rear light assembly located on inside of bed (10mm wrench) remove these and the complete light assembly comes out. do not remember which light is taillight but which ever one isn't working is the one you replace. There are 3 bulb retainers in the rear light assembly. Turn whichever bulb retainer you need to replace counter clockwise and it will come out and bulb is then accessible. If you are having constant problems with this, you may have the same problem I had and there is a recall on taillight assembly and Nissan will replace it for free. just had mine done.
Taillight bulb replacment/Taillight housing replacement * Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
* Remove the rear inside trunk finishing panel to access the taillight housing mounting nuts * Free the grommet for the taillight electrical harness and the three taillight housing nuts then pull off the taillight housing * Rotate the bulb socket counterclockwise and pull it out of the taillight housing * To remove the bulb from the socket pull it straight out.To install a new bulb in the socket push it straight into the socket until it stops
how can i replace a brakelight bulb on a 2002 nissan frontier?
Remove bedliner( if applicable). You must remove the taillight framing to get to bulbs. There are two screws located behind the taillight, that must be unscrewed to loosen the taillight frame from the truck body. Remove the two screws via the truckbed side and framing will loosen and bulbs can be replaced.
You can access the bulb from the trunk area (from behind). Just remove and replace, should be straightforward.