there are two screws or bolts that hold rear light assembly located on inside of bed (10mm wrench) remove these and the complete light assembly comes out. do not remember which light is taillight but which ever one isn't working is the one you replace. There are 3 bulb retainers in the rear light assembly. Turn whichever bulb retainer you need to replace counter clockwise and it will come out and bulb is then accessible. If you are having constant problems with this, you may have the same problem I had and there is a recall on taillight assembly and Nissan will replace it for free. just had mine done.
Hey Jerry==There are bolts that hold the light assy on. Some are hidden pretty good. GoodluckJoe
Through the inside of the bed.
When the tail light and break light are on the same bulb said bulb has 2 elements, one for the break and the other for the tail light, one element is burned out. Replace the bulb. If you've replaced the bulb, it might be the wiring. The holder for the bulb sometimes is at fault. They are $40.00 at the dealer, but at a pick a part or salvage yard they are $2.00.
Lower the tailgate and remove 2 screws. Grab taillight and pull firmly to the rear. Release tabs that hold bulb.
poke the bulb out with an ice pick.
how do you change the tail lights on a 1996 Nissan pick up?
follow the positive battery cable to the starter.
how to remove front rotors on 2003 Nissan fronter 4 wheel drive pick up
PO402 code, your EGR flow is excessive. Replace it.
To cut my work in half... Do you mean the door lock or the ignition lock ??
A few screws and clips, is all. This blown out diagram should assist you.http://www.courtesyparts.com/images/d21/d21_268-1.gif-John Bagnal
You have to do it from the inside of the trunk, peel back the carpet where the light cover would be. There are 3 11 mm bolts to remove, need and extension to reach the one. After those three bolts are removed, you can pull the plastic assembly away from the rear of the car and there are three bulbs in the assembly, pick the one you want to replace and twist it loose using by turning the plug. The bulb should just pull out, replace the bulb, use bulb grease in the socket and try not to get oil from your hands on the bulb while replaceing it, just reverse the directions to put it back together.