0
What else can I help you with?
2005 Mitsubishi galant fuel filter location?
how to change fuel pump on mitsibishi galant 2005 2.4 liter
What size is the Axle nut on a 2005 Mitsubishi galant?
32mm
2005 Mitsubishi galant service engine soon light?
How do I get the code
Where is the transmission dip stick located on a 2005 Mitsubishi galant GS?
The transmission dip stick on a 2005 Mitsubishi Galant GS is in the engine compartment, next to the engine. It is found on the driver's side of the engine.
Where is the strainer valve located in Mitsubishi galat 2004 2005 2006?
The strainer valve on the Mitsubishi Galant 2004, 2005, 2006 models is located next to the engine manifold.
Where is the oil filter in a 2005 Mitsubishi Galant LS?
It is located between the engine and firewall.
What is wrong when yo get a po401 code?
i got the code 401 for 2005 mitsubishi galant?
Where are the spark plugs on a 2005 Mitsubishi Galant?
if its got a v-6 in it it has 6, if its a 4 cyl. it has 4
Where is the egr valve located on a 2005 Mitsubishi galant?
The EGR valve, on your 2005 Mitsubishi, is located beneath the air cleaner. Remove the air cleaner housing. The valve should be visible and labeled.
How do you replace the water pump on a 2005 Mitsubishi Galant?
To replace the water pump on a 2005 Mitsubishi Galant, first, disconnect the battery and drain the coolant. Remove the timing belt by loosening the tensioner, and then take off the timing cover to access the water pump. Remove the old water pump by unscrewing the bolts, clean the mounting surface, apply a new gasket or sealant, and install the new pump. Finally, reassemble the timing belt, timing cover, refill the coolant, and reconnect the battery.
How do you change a wiper motor on a 2005 Mitsubishi galant?
The wiper motor is located on right rear of engine, hood up. Remove old wiper and replace before tightening the bolts test their location to mount.
How to Replace taillight bulb on a 2005 Ford 500?
To replace the taillight bulb on a 2005 Ford 500, start by opening the trunk and locating the taillight assembly. Remove the plastic cover or screws securing the assembly in place, then pull the assembly out gently. Turn the bulb socket counterclockwise to release it, replace the old bulb with a new one, and reassemble the taillight by reversing the steps. Finally, test the new bulb to ensure it functions properly.
