there are two screws on the inside of the taillight and then you have to slide it out from two brackets, if you can't get the brackets out you may have to pop out the plastic tabs.
remove two screws, remove tail light, remove bulb. reinstallation is the reverse of removal.
how do you replace a taillight on a Honda 2002 Civic?
Open the tailgate.Remove the taillight bolts, pull taillight toward you to release two clips.Unplug the taillight connecter.Connect the taillight connecter.Install the pushing away from you to fasten the two clips.Install the taillight boltsClose the tailgate.
how to replace the brake light switch at the pedal of a 2001 ford zx2
To replace the taillight on a 2009 Jeep Patriot, first, open the rear hatch and locate the access panel on the interior side of the taillight assembly. Remove the screws or fasteners holding the taillight in place and gently pull the assembly out. Disconnect the wiring harness from the old taillight, replace the bulb or the entire assembly with a new one, reconnect the harness, and reattach the taillight with screws. Finally, test the new taillight to ensure it works properly.
Remove the taillight assembly to gain access to the bulbs
with a screwdriver.
== ==
How do you remove taillight cover on a T-100 toyota Truck
To replace the rear taillight on a Mazda 6, first, open the trunk and locate the access panel behind the taillight assembly. Remove the screws or clips securing the taillight and carefully pull it out. Disconnect the electrical connector and replace the burned-out bulb or the entire assembly if needed. Finally, reconnect the electrical connector, reattach the taillight, and secure it with the screws or clips.
To replace the third taillight on a 2009 Kia Sportage, first, open the rear hatch and locate the access panel on the interior side of the tailgate. Remove the panel by unscrewing or unclipping it to expose the taillight assembly. Disconnect the wiring harness from the taillight, then unscrew the assembly and carefully pull it out. Replace it with the new taillight, reconnect the wiring, and reattach the access panel.
you dont