Car Computers and Sensors
Antifreeze and Engine Coolant
Ford Aerostar
Peugeot 406

How do you replace the temperature sensor on a 1993 Ford Aerostar?


Top Answer
User Avatar
Wiki User
2011-09-12 21:04:35
2011-09-12 21:04:35

Here is advice:

  • You need a 1" or 1-1/4" DEEP socket then find it on the top of the engine block towards the passenger side of the fan towards the front of the engine. Unscren coiunterclockwise. Replace with the new one and reconnect the wire/connector. That's it. Remove the Negative battery terminal for 15-20 minutes and reconnect. Then start engine.
  • the battery disconeect is to erase the signal on das from the computer after the sensor has been replaced

Related Questions

User Avatar

It appears that the Ford Aerostar with 3.0 engine does not have a crank position sensor, but the 4.0 engine does have one.

User Avatar

where is the temperature sensor 1993 BMW 318i

User Avatar

It is screwed into the exhaust manifold before the catalytic converter.

User Avatar

The 1993 Toyota coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.

User Avatar

Replace your Engine Coolant Temperature Sensor. Your car has two, replace the one with the two wire connector

Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.