To replace the thermostat on a 1996 Mazda MX-6, first, ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant from the radiator, then remove the upper radiator hose and the thermostat housing. Take out the old thermostat, clean the mating surfaces, install the new thermostat with the correct orientation, and reassemble the housing and hose. Finally, refill the coolant, reconnect the battery, and check for leaks.
the thermostat is on the lower radiator hose next to block. the thermostat is all one piece when you buy it at the store. it has 2 bolts.
Under the thermostat housing
well , there is no such thing as a mazda RX6 . im guessing you mean MX6 . totally different
The thermostat is located on the drivers' side of the engine, behind the distributor. It is between the two heads.
Take out the old ones and replace them with new ones.
open boot/trunk undo 2 screws on top of rear lens and slide out replace bulbs and refit
its just above the transmission in between the cylinder heads
In a 1994 Mazda MX-6, the thermostat is located in the engine compartment, specifically at the engine end of the upper radiator hose. To access it, you'll need to remove the upper hose and the thermostat housing, which is typically bolted to the engine block. Make sure the engine is cool before attempting to locate or replace the thermostat to avoid burns.
most parts are yes. most parts are also interchangeable for ford probes of the same year range (excluding body parts of course --- Many interchangeable parts on 1993 Mazda Mx6: 1993-1996 Mazda 626 1993-1996 Ford Probe some parts off the Mazda MX3 some parts off the 1998-2003 Mazda Protege some parts with 1996 are not compatible due to OBDII legislature, which changed emissions and other changes.
I would say 10w-40 Castrol Magnatec
mx6 got no moonroof - only a sunroof and YES its interchangeable
afew bucks pretty cheap price it out and it will surprise you...