0
What else can I help you with?
What can you do to increase hp on a 1988 v6 firebird?
replace the engine with a small block chev
How much does it cost to replace a clutch on a 1988 fiero gt v6?
i paid 500+ tax
Where is the thermostat located on a 1995 Chev Blazer V6 engine?
remove the hose and look into the housing the thermostate should be there
1988 Ford Ranger 2.9 V6 no heat?
replace the heater core if that's not it start checking fuse
Have 89 olds with v6 engine cuts out but starts up again?
Your 89 olds is giving signs of a weak or faulty fuel pump. Think about changing fuel filter first,if no improvement replace fuel pump.
How do you replace a serpentine belt on olds cutlass supreme 1988 2.8 l v6?
To replace the serpentine belt on a 1988 Oldsmobile Cutlass Supreme with a 2.8L V6, first, locate the belt routing diagram, usually found on a sticker in the engine bay. Use a socket wrench to relieve tension on the tensioner pulley and remove the old belt. Install the new belt by following the routing diagram, ensuring it sits securely in all grooves. Finally, check the tensioner to ensure proper tension on the new belt before closing the hood.
How do you increase horsepower on a v6 1988 firebird?
how do you increase horse power on a 1988 v6 firebird
How can a leaking head gasket on a olds cutlass ciera 2.8 L V6 be repaired?
You will need to remove the intake and the exhaust manifolds and then you can remove the heads to replace the gaskets.
Where are the coil packs located on a 99' Olds Cutlass GL and are they easy for a do-it-yourselfer to replace?
The coil packs should be low in the front if you have a V6( just follow the plug wires). Yes, they are easy to replace on every vehicle I have done.
What cylinder heads will fit a 2003 olds silhouette?
what heads will fit on my 2000 olds silhouette v6 3.4
How many hours does it take to replace an exahust manifold on a 1988 Toyota V6 Pickup?
depends on who does it...normal time bein 3-5 hours
How do you replace the o-ring on the high pressure side of the fuel rail on a 1998 Olds Achieva 3100 V6 motor?
Put the "O" ring on the line and lubricate it with a little silicone.
