Want this question answered?
Hey Howard===Your question makes no sense whatsoever. Joe
A= Replace engine oil1= Rotate tires3= Replace the transmission fluid and transfer fluid (if equipped)6= Replace the rear differential fluid (if equipped)
NO. If you keep finding yourself ADDING transmission fluid often and you have no leaks but the transfer case is over full then you need to remove the transfer case and replace the seal in the transfer case where it bolts to the rear of the transmission.
how do you add transmission fluid on 98 acura cl 3.0
remove bolts from caliper and loosen break fluid release valve. remove assembly from rotor. the best way to depress piston is to use a large c-clamp. install new pads, replace assembly, replace brake fluid, bleed the lines, CHECK FLUID LEVEL, done!
Honda ATF-Z1 fluid, you have to get it from your Honda/Acura dealer.
The transfer of heat by fluid is convection.
Fluid shift is the transfer of fluid from blood to interstitial fluid (IF). This transfer changes blood and IF volumes.
It is important to use the correct amount of fluid in a car. The 1988 Acura Legend takes about 3.2 quarts of transmission fluid.
Honda- Acura ATF or Dextron III
There is a sensor in the top of the brake cylinder where you put in the fluid. Replace it and the light will go away.
It is critical that you use only Honda ATF. Do not use any other fluid, no matter what anyone tells you. Your Acura will not shift properly with any other fluid and you it may be damaged. Purchase the fluid at your Honda/Acura dealer.