unbolt the old one put in the new one
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
From in the trunk
When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.
in the trunk
my integra was getting a lot of water in the trunk because of the taillights so check those
2 plastic pieces inside the trunk where the taillights are, they should just pop off
Yes, it will. I have a 94 integra ls and i have two 12's in the trunk.
To replace the trunk strut on a 1999 Ford Contour, first, securely prop the trunk open to prevent injury. Use a socket wrench to remove the bolts securing the old strut at both ends. Carefully detach the old strut and align the new strut in place, securing it with the bolts. Finally, repeat the process for the other strut if necessary, ensuring everything is tightened properly before closing the trunk.
These are the things that you should have: Screwdriver Hood Prop Trunk Strut And these are some general steps: 1. Open the trunk. 2. Prop open the trunk 3. Remove the retainer bolts from the top and unscrew lower end of the old shocks. 4. Remove the weak trunk strut 5. Install the new strut. Replacing struts in pairs is recommended. 6. Remove prop rod. 7. Inspect and test the trunk to verify the trunk strut repair.
To replace the rear struts on a 1997 Acura TL, start by safely lifting the vehicle and removing the rear wheels. Then, unbolt the strut from the lower control arm and the top mount inside the trunk. Remove the old strut and install the new one by reversing the process, ensuring all bolts are torqued to specifications. Finally, reattach the wheels and lower the vehicle to the ground.
under neather the carpet in the trunk unless someone stole yours.
To replace the front and rear struts on a 1999 Acura CL, start by safely lifting the vehicle and removing the wheels. For the front struts, disconnect the sway bar link, brake line bracket, and the strut top mount under the hood, then remove the strut assembly. For the rear struts, access the top mount from the trunk, then unbolt the strut from the lower control arm and remove it. Install the new struts in reverse order, ensuring all bolts are tightened to the manufacturer's specifications.