0
The rivet holding the old ball joint in place must first be drilled out. Use a punch and hammer to put a divit in the top of the rivet, drill a small hole then a larger hole through the rivet. Use a hammer and chisel to cut off the head of the rivet and then hammer out the rivet. The new ball joints are installed with small bolts.
What else can I help you with?
Where is the Fuel Injector Pressure Regulator located on 01 Chevy astro?
It is inside the upper intake manifold. It is attached to the fuel injector poppets with a bracket. To inspect/replace you must remove the upper intake manifold.
How do you replace upper ball joint on 2002 sierra?
Part Of Upper Control Arm
1994 Chevy astro fuel regulator location?
it is part of the fuel injector which is under the upper intake manifold
Where is the thermostat located in a 1995 Chevy Astro van?
Look where the upper radiator hose connects to the engine. There you will find the thermostat.
How long does it take to change the upper intake gasket on a 1992 Chevy astro van with a 4.3?
It took 4.3 hours
How do you replace upper ball joint on a 98 ranger?
u can't just change the upper ball joint, u have to change the whole upper control arm. It is welded to the arm in one piece.
How do you replace driver side upper Ball joint in a 1995 Lincoln Mark VII?
You have to change the upper control arm.
How do you change a upper passanger side ball joint on a 1994 Chevy silvarado 4x4?
if it is original the upper ball joint is riveted in, it will need to be chisel out,there are four rivets and then the nut that holds it to the control arm.new ball joint will come with bolts and nuts
Where is fuel pressure regulator located on 1998 Chevy astro van?
It's part of the fuel injection assembly inside the upper manifold.
How do you find the thermostat in a 1989 Chevy astro van?
if you follow the upper rad hose towards the engine, where the hose attaches to the motor it is under that housing.
How do you remove upper ball joint on 1996 Chevy blazer?
Just learned this the hard way today after trying to do it myself. The ball joint will not come out until you remove the brake caliper and rotor. Too time consuming for a do it yourselfer in my opinion...I had the shop down the street replace the ball joint for 1.1 hours labor (about $80).
How do you replace the upper ball joint on a 1992 Acura Vigor?
To replace the upper ball joint on a 1992 Acura Vigor, start by lifting the vehicle and removing the front wheel for access. Disconnect the upper control arm from the steering knuckle and any associated components, then remove the ball joint retaining nut. Use a ball joint separator or a suitable tool to detach the ball joint from the control arm, and replace it with a new one, ensuring proper alignment. Reassemble all components, torque the fasteners to the manufacturer's specifications, and reinstall the wheel.
