answersLogoWhite

0

Should be hel in place by 2 small screws in side the distributor cap

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

How do you replace blinker switch on a 1976 Chevy Corvette?

== ==


How can you make a 1991 Chevy 305 work in a 1976 impala?

unless you are willing to install the ecm and wiring harness,you will have to replace the distributor with a pre 1980 distributor. reason for this is to get vacuum advance. you also will have to replace intake manifold with a manifold for a carb. a edelbrock and a edelbrock carb work well for me. the rest should work. also use the exhaust manifolds from the 76. good luck


How do you remove the Ignition Key Lock Cylinder to replace it on a 1976 Chevy Blazer?

this site will help


Where does the vacuum line for a 1976 jeep go?

In a 1976 Jeep, the vacuum line typically connects to the intake manifold or carburetor to facilitate proper engine operation. It may also connect to various components such as the distributor vacuum advance, the climate control system, or other accessories that require vacuum pressure. For specific routing, it's best to consult the vehicle’s service manual, as configurations can vary based on the model and engine type.


Could you show me a Vacuum hose diagram for 1976 Malibu Classic?

show me vacuum diagram on 1976 malibu


Where do vacuum lines go on a 1976 trans am 400?

On a 1976 Trans Am with a 400 engine, vacuum lines typically connect to various components such as the intake manifold, carburetor, and emissions controls. The main vacuum source is usually from the intake manifold, which supplies vacuum to the brake booster, HVAC controls, and any vacuum-operated accessories. Additionally, there may be lines leading to the distributor for advance timing. It's essential to refer to a service manual for specific routing details, as configurations may vary based on options and emissions systems.


How do you Replace a radio for a 1976 Chevy Nova?

When you pull the knobs off, the remaining studs wi;ll have thin nuts on them. Remove these, and it will pull out of the back.


1976 280Z stumbles over 2500 rpm?

Vacuum advance may not be working properly. Check internet for many possibilities or problems, start with tubing and work back to the distributor. Good skills fixing your problem.


Does 1976 half ton Chevy truck need to have a catalytic converter?

does a 1976 3/4 ton chevy truck have to have converters on it


How to route Vacuum line on 1976 Oldsmobile 88 carbureter?

To route the vacuum line on a 1976 Oldsmobile 88 carburetor, first locate the appropriate vacuum ports on the carburetor, typically found on the throttle body or intake manifold. Connect the vacuum line from the port to the desired accessory, such as the distributor advance or emissions control devices, ensuring that the line is securely attached and free of leaks. Be sure to check for any specific routing diagrams in the vehicle's service manual for precise connections. Finally, verify that all connections are tight and that there are no kinks in the line.


What year did Chevy Chase leave Saturday Night Live?

1976


How do you replace the trunk lock on a 1976 Chevy Nova?

To replace the trunk lock on a 1976 Chevy Nova, first, open the trunk and remove the screws or bolts securing the lock mechanism to the trunk lid. Disconnect any wiring if applicable, then pull the old lock out. Insert the new lock into the same opening, secure it with the screws or bolts, and reconnect any wiring. Finally, test the lock to ensure it operates properly.