0
depending on engine size a 3.1 liter v6 and a 2.2 lier 4cyl. are both located in the front of the engine. remove serpentine belt,remove 4 10mm from pulley (v6)(three 13mm for 4cyl.)remove pulley.v6 will have 6 8mm bolts,4cyl. will have 4 13mm bolts-remove clean surfaces install new pump.about 20 mins.v6,30mins for 4cyl.be sure to drain coolant before you start,refill with proper coolant,some 95 up gm require dexcool anti freeze (orange in color).easy.gm Jim
What else can I help you with?
How do you replace the water pump on a 1995 Chevy Corvette?
== ==
Spark plug gap Chevy beretta 1995?
0.060
I have a 1995 Chevy Beretta with a bad 3.1L and a 1993 Chevy Lumina with a good 3.1L motor is this a possible swap?
the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta
Where is the transmission solenoid on a 1995 Chevy beretta?
inside the transmission bell housing
Where is the fuel filter located on a 1995 Chevy Beretta?
Behind the fuel tank.
Where is the temperature sending unit for a 95 Chevy beretta?
The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.
Where is the fuel pressure relief valve on a 1995 Chevy Z26 Beretta?
In the gas. Of course.
Why does your 1995 Chevy beretta taillights keep blowing the fuse Help?
then there is a short some where!
Where is a thermostat in a Chevy beretta v6 1995?
Follow the upper radiator hose to the engine. It is behind there.
Will a 1995 Chevy Beretta 3.1 engine work in a 2001 Chevy Malibu 3.1?
As long as the are both front wheel drive.
How do you replace outside door handles on a 1995 Chevy Beretta?
When you take the old one off you will see how the new one goes on. It's very simple & I've done it! Good Luck!
What is the firing order on a 3.1 for a 1995 Chevy beretta?
1-2-3-4-5-6
