Add your answer:
Spark plug gap Chevy beretta 1995?
0.060
I have a 1995 Chevy Beretta with a bad 3.1L and a 1993 Chevy Lumina with a good 3.1L motor is this a possible swap?
the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta
Where is the transmission solenoid on a 1995 Chevy beretta?
inside the transmission bell housing
Where is the fuel filter located on a 1995 Chevy Beretta?
Behind the fuel tank.
Where is the temperature sending unit for a 95 Chevy beretta?
The temperature sending unit for a 1995 Chevy Beretta is on the front of the engine. It is between the front of the engine and the radiator inlet/outlet.
Where is the fuel pressure relief valve on a 1995 Chevy Z26 Beretta?
In the gas. Of course.
Where is a thermostat in a Chevy beretta v6 1995?
Follow the upper radiator hose to the engine. It is behind there.
Will a 1995 Chevy Beretta 3.1 engine work in a 2001 Chevy Malibu 3.1?
As long as the are both front wheel drive.
What is the firing order on a 3.1 for a 1995 Chevy beretta?
1-2-3-4-5-6
Where is ac compressor relay on 1995 Chevy beretta ac clutch will not kick in.?
You are low on refrigerant, google R134a...
How to tell if abs brake pump is bad on 1994 Chevy beretta?
it is a 1995 Chevy blazer and it will not go into park. have to use the emergency brake when stopped, and neutral to start it
How do you change an O 2 sensor for a 1995 Chevy Beretta?
It requires a special socket with a slot in the side so as not to harm the wiring.
Can you put a transmission from a 1992 Chevy Corsica into a 1995 Chevy Beretta?
Only the 5-speeds. You can't swap automatics without running into problems, and you can't swap an automatic for a 5-speed without modifying (and it will still throw an engine code afterward). A 1992 Corsica had a 3T40 automatic, and the 1995 Beretta had a 4T60E automatic. Your best bet is to swap in another 4T60E. It came in a lot of GM vehicles. Go to car-part.com and enter "1995 Chevy Beretta automatic transmission" in the search for a list compatible transmissions and prices in your area.
How do you remove the center console on a 1995 Chevy Beretta?
Hi there, there should be four screws inside the centre console if you undo them your well away :)
Can you put a 1993 beretta transmission in a 1995 beretta?
Yes if the engines are the same
Where is fuse location for taillights on a 1995 Jeep Cherokee?
Where is taillight fuse on a 1995 Jeep Cherokee?
Where is the horn fuse relay on a 1995 Chevy Beretta?
Two separate items there. There is a horn fuse and a horn relay. Location can be found in the owners manual.
Your shifter knob on a 95 Chevy Beretta broke off from the metal bar it is attched to what is that piece called?
If the shift knob on a 1995 Chevy Beretta broke off from the metal bar, the metal bar is called the shift lever. The shift lever might be available at a reduced price from an automobile salvage yard.
Is the fuel pump on a 1992 Chevy Corsica the same as one from a 1995 Chevy Beretta?
No. The fuel pumps changed in 1993 to a different design, from that point on the pump and sending unit were integrated into one unit. They will not interchange.
Where are the wires leading to the taillights on a 1995 Chevy S-10 4-cylinder?
Should be in a harness running along the frame rail to a connector at rear lower end of body
Where is the fuel pressure test port on a 1995 Chevy Beretta?
There is no schrader valve, you need to source an adapter to place between where the fuel line attaches to the intake manifold.
I have a 1995 Chevy Beretta . What would make the low coolant light stay on when there is enough coolant in the car?
There is a sensor valve located inside the reservoir its may be bad
Can oil leak from the starter on a 1995 Chevy Beretta 3.1?
No, oil doesn't come out of the starter, either your distributor plug is leaking or you are leaking oil out of your front valve cover.
What is the cause of a fuse blowing on a 1995 Chevy Corsica as a result of using the heater or air conditioner?
It really needs to be checked out but it probably is the blower votor.
What size torx do you need to remove the front caliper of a 1995 beretta?
A 1995 Beretta front brake caliper is not held on by a Torx bolt. Use a 3/8" Hex key.
Get the Answers App
