Remove the intake manifold, exhaust manifold, and then remove the head. Scrap off the old gasket and install a new one. Reinstall the head and Torque the head bolts in the proper sequence. Reinstall the intake and exhaust manifold torque the bolts to the proper torque. This is a major repair and not for a novice to try.
My 1997 318i has an external oil leak from the head gasket, I was quoted $1200.00 to $1400.00 if I also have to get the valves done. A little under $1000.00 if not.
No risk just make sure head is not warped before replacing gasket Is this a quad 4 motor????????????????????
15.00. for gasket and thermostat
Hopefully, it's the thermostat... but, if the engine has seriously overheated it could be a damaged head gasket caused by a warped head. Engine heads will warp slightly when the engine overheats, then there is insufficient pressure on the head gasket and the gasket will leak.
Depending on the failed section of gasket, either the engine coolant ( anti freeze) will mill with the engine oil making a creamy, expensive mess. or exhaust gases entering the cooling system
Replace the gasket.
1500
Gasket should be included with new oil filter
not sure if this will help but, try mademan.com/mm/how-install-head-gasket-1996-jaguar-xj6.html
To replace the head gasket on a 1994 Oldsmobile Cutlass 3.4L, everything on the top of the motor needs to be removed. The battery should be unhooked first, then the valve covers, then the head itself. Replace the new gasket after cleaning the old gunk off from the first gasket. It is a good idea to take a picture before, during, and after, to make sure everything is hooked up like it should be. One note, the valve cover gasket will also have to be replaced after removal.
Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"
You are looking at bill of 1-3K depending on damage.
Open the air cleaner box lid, remove the old, put in the new, put the lid back.
Replace the whole rack, it would take speical tools to replace seals
What size engine? 3.1 or 3100? yes there is a difference. j1taylor@twcny.rr.com
Drop the lower transmission pan Clean pan Replace filter and gasket
instructions for changeing the head gasket on 93 BMW 325i m 50 motor, does the timing chain have to be romeved and what are the torque tolerences for the bolts.