0
What else can I help you with?
How do you replace the head gasket located on a 1994 Oldsmobile Cutlass 3.4L?
To replace the head gasket on a 1994 Oldsmobile Cutlass 3.4L, everything on the top of the motor needs to be removed. The battery should be unhooked first, then the valve covers, then the head itself. Replace the new gasket after cleaning the old gunk off from the first gasket. It is a good idea to take a picture before, during, and after, to make sure everything is hooked up like it should be. One note, the valve cover gasket will also have to be replaced after removal.
How do you replace the thermostat located on a Oldsmobile Custom Cruiser?
remove old thermostat and replace with new thermostat and gasket
What causes transmission fluid to leak on a 1970 Cutlass Oldsmobile?
A transmission fluid leak means that the plug may need to be replace, or the seal or gasket may need to be replace. As it could be caused by a work seal, or gasket, or a loose plug.
How do you replace water pump in 1986 Oldsmobile cutlass supreme?
To replace the water pump in a 1986 Oldsmobile Cutlass Supreme, first disconnect the battery and drain the coolant from the radiator. Remove any components obstructing access, such as the serpentine belt and the alternator, if necessary. Unbolt the water pump from the engine block, clean the gasket surfaces, and install the new pump with a new gasket. Reassemble all components, refill the cooling system with coolant, and check for leaks after starting the engine.
Why does your 1987 Oldsmobile cutlass keep overheating?
Possibilities are low coolant, defective radiator, leaky hoses, blown head gasket...
What would cause antifreeze to disappear in an Oldsmobile 1989 cutlass calias quad 4?
If there are no visible leaks....a blown head gasket.
How do you change the lower intake gasket on a 95 Olds Cutlass Supreme 3.4DOHC?
Remove the 1995 Oldsmobile Cutlass intake manifold retaining bolts. The manifold will come off. Remove the old gasket. Clean the surface. Put the new intake gasket and tighten the intake manifold retaining bolts.
How do you replace the head gasket located on a 1989 Mazda B2200 1.3L?
replace head gasket
Where is the head gasket located on a 1999 Oldsmobile?
There are 2 of them. They are sandwiched between the heads and the engine block. In order to replace them the intake manifold and heads must be removed and exhaust manifold disconnected. Always replace both of them on a V6.
How do you change the thermostat on a 1989 Cutlass Ciera?
the thermistat is located inside the upper radiator hose, where it connects to the motor. have the car off and cold. just unbolt it and pull the old w/gasket. replace with new and gasket. bolt in. the attach hose. top off antifreeze
Fuel pump replacement instructions and type on 1983 Oldsmobile cutlass?
Mechanical engine mount? Remove old one Install new making sure cam is under lever to activate replace mounting gasket and fuel lines Mechanical engine mount? Remove old one Install new making sure cam is under lever to activate replace mounting gasket and fuel lines
How do you change a gasket on a Oldsmobile bravada?
The gasket on an Oldsmobile Bravada is changed by removing the retaining bolts, taking off the cover, and peeling the gasket off. The surface is then cleaned and a new gasket put in place.
