Want this question answered?
For the Ford KC laser, the 1.6L motor is 2degrees BTDC for both the EFI and carby motors, while the 1.3L is 6degrees BTDC. For the 1.6L EFI engine, you need to plug the distributor vacuum line, not for any of the others.
yasmin carby
Fanny Carby is 5' 4".
Firstly, only push the accelerator down once before starting. Use a torch and check the sight glass on the side of the carby to see if the level of fuel is at the center. If not, then you will need a new'Needle and Seat' in the carby.
Usually a timing problem. However, it could be the way the carb is tuned or a vacuum leak. Start by checking your timing and looking for vacuum leaks.
Most usual reason is the ignition module in the distributor, or it could be the float needle sticking if it is the carby model.
Fanny Carby died on September 20, 2002, in London, England, UK..
Fanny Carby was born on February 2, 1925, in Sutton, Surrey, England, UK..
What is a carby??? If you mean carburetor then the answer is no. The carburetor body should not move.
Hazel V. Carby has written: 'Race Men (The W. E. B. Du Bois Lectures)'
On these type of bikes its a physical restriction in the carby i think all you need to do is to take out the carby sliders. if you want you can replave them with the ones from the sv650
Close choke (if equiped), if not, consider servicing the carby or the fuel pump. * This answer is answered in assumption that it runs after start. If you have to put petrol down the carby to keep it going, consider servicing/replacing the carby