Raise hood. There is a long plastic cover across the front end of the engine compartment. Carefully pop out some of the plastic rivets holding the plastic cover. Reach down behind the headlamp area where the turn signal light is located and unscrew bulb holder about 1/8 turn to remove. The bulb can that be twisted out of this socket/holder. Replace with new bulb and replace bulb holder into back of headlamp assembly. Note, the bulb holder is keyed to start in only one position before screwing into place. Replace plastic cover with rivets. ---- SHORT CUT, reach up from under the car, you can grab the bulb. You can't see it while you are doing it but it is much easier than taking plastic cover off
Underneath Driver side dash kick panel
The owner's manual will tell you the exact location. They may be on the driver's side, just to the left of the steering column underneath. Or under the hood on the right. They are to access and inexpensive to replace.
Stopped!
The vehicle speed signal comes from the transmission output speed sensor on the front driver side of the transmission case.The vehicle speed signal comes from the transmission output speed sensor on the front driver side of the transmission case.
if indicator flasher is signal relay then its underneath dashboard, driver's side..
Avoid motor-vehicle accident
a Phillips head screw driver
What kind of vehicle (make & model)?
yes, you have to signal your turning actions at least 100 feet.
underneath driver's side lower dash plate. it will be on your right hand side.
Front signal bulbs on a RSX are changed from the engine bay. Find the lightbulbs for the signal bulbs located towards the bumper of the vehicle. Pull them out and replace them.
under the driver side, take off the cover plate and its located to the right underneath the steering wheel.