Rear or front?
rear
The wheel bearings are not really replaceable by themselves. This is because they are integrated into the hub assembly. So the answer is that you will have to replace the entire hub assembly to replace the bearings.
taking out rear hub asembly on a 2002 Chevy ventura
To replace the front bearing,jack up front and remove the wheel.Remove the brake caliber assembly and pads.The brake caliber guide ,held in place by 2 bolts that is bolted to the hub assembly has to be removed in order to remove the rotor.Remove the 3 bolts which hold the wheel bearing to the hub assembly,from the backside.Remove the 35mm axle nut using an inpact drill or strong arm.Tap the axle out of the assembly and the bearing assembly should come out from the front.
the bearing assy comes as a complete package with the hub and ABS sensor, etc. --- 3 bolts connecting it to the knuckle (front) or arm (rear)
have a garage do it. it is a pain in the rear. you have to drop the basket 1st. with a new one and labore your looking at about 1300$. i just had it done.
how do you replace a wheel bearing assembly on the left side of a 2007 chevy tahoe with 4wd and abs brakes
If you're trying to replace the rear wheel bearing and all you can find is the rear hub assembly, it probably means that you can't get just the bearing. Many vehicle manufacturers press the bearing into the assembly at the factory and there is no way to replace just the bearing. If they're offering the assembly, that's probably what you'll need to buy.
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
The wheel bearings in the vans are "integrated" as part of the hub assembly. This is because of the wheel speed sensor, which are part of the Anti-lock Breaking System (ABS). In order to replace the bearings, you have to replace the entire hub assembly. These are not cheap, as a result of the included sensors. Sorry about that. Good Luck, Greg A.
Yes, I have had to replace both on my van.
you need to press out the bearing inside the hub assembly.
Front or rear?