I have a outside motion sensor light and I need to re program the wall switch.How do I reprogram the wall switch?
Thank you
In most motion sensor switches you will have three wires. A black, white and red wire. The black and white (neutral) are used for the electronics in the sensor. These connect to the incoming black and white power. Connect the lamp across the red and the white (neutral). When the sensor detects motion the red wire becomes "hot" and the light will go on.
"Wall Switch plates vary in price. The average wall switch plate will be around seven dollars. For larger or more decorative wall switch plates, the price may increase up to thirty dollars."
its probably old get an electrician to replace it
If the wall switch is on, the three way lamp switch should work. If it doesn't, it may be broken or there may be something else wrong with the circuit.
If you are referring to a switched UK-style socket outlet fitted with a led, or a wall switch fitted with a led, then the led merely indicates that the socket outlet switch or wall switch is in the 'on' position.
You need to set up a pressure switch or a motion sensor switch.
Each fixture will have to have it's own motion sensor, then yes it will work.
In most motion sensor switches you will have three wires. A black, white and red wire. The black and white (neutral) are used for the electronics in the sensor. These connect to the incoming black and white power. Connect the lamp across the red and the white (neutral). When the sensor detects motion the red wire becomes "hot" and the light will go on.
Most likely the room has some sort of motion sensor to tell if someone is present. A heat sensor can tell if a person is in the room by the heat generated by the human body. A sound sensor can respond to noise made by a person walking, talking or otherwise. Either will work. The triggered sensor can turn on the lights or anything else electrically. The lights are usually attached to some kind of timer so that if no activity is detected in the room for a while, the lights are turned off until the next time the sensor is triggered.
Is this security light the type with the built-in motion sensor? If so, these also have a built-in photo-eye so that it does not come on during the day. The photo-eye can go bad where the symptom is "on all the time" Also some of the motion sensors have a chip inside that "locks on" if you flip the wall switch on and off three times quickly. Once "locked-on" I think you have to turn the wall switch off for at least 1 minute to reset.
"Wall Switch plates vary in price. The average wall switch plate will be around seven dollars. For larger or more decorative wall switch plates, the price may increase up to thirty dollars."
Regional Wall Motion Abnormality
A book on the table. Pushing the wall. Motion of man on ground.
A book on the table. Pushing the wall. Motion of man on ground.
No, you might have a bad map sensor, disconnect and try starting the car. The map sensor is located above the power steering pump, attached to the fire wall. With one connector and a hose. F. Garay
how do you turn a light sensor on, on a outdoor wall light fixture
its probably old get an electrician to replace it