remove the negative cable from the battery and push your brakes about 5 times. Don't reconnect the negative cable until about an hour after you've pushed the brakes.
No, offset is different.
Remove the fuel tank or remove the bed.
The engine computer is at the base of the windshield under the hood, under the wiper cowl.
03, 04, and 05 Dodge Dakota 4.7, and jeep grand Cherokee motors of the same years. Some 02's will work if they have the 24 tooth crankshaft wheel. The 5.9's and 5.2's will not.
5/16 inch or 1/2 inch, depends on trans type.
the only dakotas that can use the ram wheels are the 05-up 5 lug pattern Dakota and durangos that share the dodge ram pattern. the 6 lug dakotas 92-04 will not wokr bc of different lug patterns
1987-93 = 85 ft lbs 1994-05 =100 ft lbs 2006 =140 ft lbs
Inside the pan, bolted to the bottom of the transmission.Inside the pan, bolted to the bottom of the transmission.
Dakota Cochrane was born on 1986-05-01.
you have to grind the welds that hold the frame rail to the rest of the frame and slide the ends out . replace the frame rails and weld it back.
To reset the computer on a 2005 Dodge Magnum, first disconnect the negative battery cable and leave it disconnected for about 15 minutes. This will allow the onboard computer to reset. Reconnect the negative battery cable, and then turn the ignition to the "ON" position without starting the engine for about 10 seconds to allow the computer to recalibrate. Finally, start the engine and let it idle for a few minutes to ensure the reset is complete.
It is controlled by the ECU, which you cannot remove.