you want to put the key in the start (AC) pos. and then put the + side of the bat on and then turn the key of and the alarm should not go on
Insert key into driver door and turn to the unlock position. This should turn off the alarm.
To reset the car alarm in a 1994 Jetta, start by unlocking the driver's door with the key. If the alarm is still active, insert the key into the ignition and turn it to the "On" position without starting the engine. This should deactivate the alarm. If the alarm persists, disconnect the battery for a few minutes to fully reset the system.
on my 97 jetta (same model) just open the trunk with your key and then close it
if you have a factory alarm..you will need a power remote to reset the alarm. or you can reset the alarm be using the key in any of the door locks or in the rear hatch lock . just cycle the key to the unlock position to shut alarm off. to reset alarm to armed use the door lock power switch to lock the door then shut door and alarm will reset to on .
No. The factory alarm is reset with the remote or by turning the key in the door locks.
When the horn starts honking I reset the alarm system on my 1997 Jetta GT by disconnecting the battery cable and waiting a few monutes and then reconnecting the battery cable. You can also unlock the driver's door with the key and it should stop.
To disable the car alarm on a 1996 VW Jetta, you can try using the key to unlock the driver's door. This often deactivates the alarm system. If that doesn't work, you can disconnect the car battery for a few minutes to reset the system. Finally, if the alarm persists, consult the owner's manual or a professional mechanic for further assistance.
-I was to;d that only the dealer can do it.They need to send to Germany for a new code and then they reprogram the remote.
Consult the factory. It is extremely difficult to do as they do not provide instructions like some other manufacturer's do.
how to reset alarm
If your Battery is low the alarm will go off. You can also pull the Neg. battery cable to reset. BUT have someone standing by the drivers door with the key in the door lock. It must be turned once the reconnection is made. This will reset the alarm. If that doesn't work you will need to look for broken or loose wires with a wire diagram of the alarm system.
Sphero locks cannot be reset - only resettable locks can be reset. The Sphero locks come with a permanent combo.