answersLogoWhite

0

With engine off. Turn key to on. Press accelerator fully three times. This should reset light.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

What does a change oil light mean in at 2004 Chevrolet impala?

Time to change your oil in your engine!


How do you reset engine light on 96 Chevy Impala?

Use an OBD scan tool to reset or disconnect the battery


What does service engine soon light mean on a 2000 Chevy Impala?

It means that the engine computer has detected a malfunction that will affect the emissions of the vehicle.


How do you replace a breaklight on a 2009 Chevy Impala LT?

you just open the light and change it or pet boys


Reset oil light on 2002 Chevy impala?

See How to Reset the Change Engine Oil Message on page 6-18 of your "Owner's Manual", under Section 6: Service and Appearance Care - Engine Oil...


Why does my Check engine light stay on in my 2001 Chevy Impala?

Check engine is an error. You have to go at a garage to see what is the error code, then correct the problem.


How do you reset oil change light on Chevy Impala 2000?

Turn on the ignition but do not start the engine. Depress the accelerator to the floor 3 times within 5 seconds. The oil light should blink and then go out.jd


Why would a check engine light on a 2002 Chevy impala come on?

You need to connect a OBD-II Scanner to find out.....


Chevy Impala 2001 service traction light on?

Hi i have an 2001 Chevy impala and my service traction Light is on. plus my safety brake is locked


How to change bulb to tag light on 2002 impala?

How do you change a tag light on a 2002 impala


Where is the power steering fluid reservoir located in Chevy Impala 2001?

If the Impala is the same as my 2001 Monte Carlo with a 3.8 L engine, the resivoir is on the pass. side way down low in back of engine compartment. You need a bright light to see it and it is very hard to get at!


What causes a 454 motor in a Chevy impala's the temperature light to come on and it's not running hot?

A faulty sensor in the engine block.