With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
To reset the oil change light on a 2013 Chevy Impala, first turn the ignition to the "On" position without starting the engine. Press the gas pedal three times within five seconds. After that, turn the ignition off, then start the engine to ensure the oil change light is reset. If the light remains on, repeat the process.
Time to change your oil in your engine!
Use an OBD scan tool to reset or disconnect the battery
It means that the engine computer has detected a malfunction that will affect the emissions of the vehicle.
you just open the light and change it or pet boys
See How to Reset the Change Engine Oil Message on page 6-18 of your "Owner's Manual", under Section 6: Service and Appearance Care - Engine Oil...
Turn on the ignition but do not start the engine. Depress the accelerator to the floor 3 times within 5 seconds. The oil light should blink and then go out.jd
Check engine is an error. You have to go at a garage to see what is the error code, then correct the problem.
Hi i have an 2001 Chevy impala and my service traction Light is on. plus my safety brake is locked
You need to connect a OBD-II Scanner to find out.....
How do you change a tag light on a 2002 impala
If the Impala is the same as my 2001 Monte Carlo with a 3.8 L engine, the resivoir is on the pass. side way down low in back of engine compartment. You need a bright light to see it and it is very hard to get at!