SETTING TIME for EnviraStation DWS-320
RADIO-CONTROLLED CLOCK
The home receiver will start synchronizing the clock after the 1st channel of
the RF thermometer is registered.
1. At normal mode, hold the " - " button located on the back of the home
receiver for 3 seconds to force synchronization.
2. The antenna icon will appear during the synchronization process (on the
right side of the time display).
3. If the icon disappears afterwards, radio time signal is not available at that
moment. Try setting the home receiver in other locations. Remember to
place the unit away from sources of interference such as mobile phones,
appliances, TV etc.
4. Antenna icon will appear on screen if the radio time reception is
successful. The radio-controlled clock will have a daily synchronization at 1:00 am everyday. If previous attempts of reception were
unsuccessful, the home receiver will attempt synchronization
each hour until successful.
5. Each reception cycle is minimum 2 minutes and maximum 10 minutes.
MANUAL SETTING FOR CLOCK & CALENDAR
1. Hold "SET " button for 3 seconds to enter clock set.
2. First, select 12 hour or 24 hour setting using the " +, - " buttons located
on the back of the home receiver. Press " SET " button to confirm.
3. Select Hour - Use the " + , - " buttons located on the back of the home
receiver to adjust hour setting. Press " SET " button to confirm.
4. Select Minute - Use the " + , - " buttons located on the back of the
home receiver to adjust minute setting. Press " SET " button to confirm.
5. DST On/Off (Daylight Savings Time) - Use the " + , - " buttons to turn
DST on or off. Press " SET " button to confirm.
Now you will select the calendar settings-
6. Select Year - Use the " + , - " buttons located on the back of the home
receiver to adjust year setting. Press " SET " button to confirm.
7. Select Month - Use the " + , - " buttons located on the back of the
home receiver to adjust month setting. Press " SET " button to confirm.
8. Select Day - Use the " + , - " buttons located on the back of the home
receiver to adjust day setting. Press " SET " button to confirm.
9. Select Fahrenheit/Centigrade Temperature Readings - Use the
" + , - " buttons located on the back of the home receiver to toggle
between Fahrenheit or Centigrade readings. Press " SET " button
to confirm.
10. Time Zone Selection
Press " - " button on back of home receiver to select from the following time
zones in the U.S. (zone is displayed in the upper right hand corner of time
display). Press " SET " button to confirm.
To set time zones push the (-) button on back
Humidity would not be included in a station model.
A station model represents weather data
meteorologist is a person who studies the weather and a station model is a design made to study weather
A map that includes station model symbols and imformation about fronts and about centers of high pressure and low pressure.
The weather information collected by meteorologists at specific locations is called a station model.
Station Model.
A station model.
interpret a station model and find relative humidity from data shown in model
station model
Humidity would not be included in a station model.
Barometric pressure
The two anagram words are "station model."
A station model represents weather data
Of a 2001mazda platinum station wagon
station model
None
the barometric pressure