The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The ABS light is on because there is a fault in the system. Once the fault is repaired or fixed the light will reset itself. The ABS system can be scanned for codes to help diagnose the problem.
You can't reset the parking light - It shows you have a fault at that time - Cure the fault and the light will go out - I have a problem with mine - I have an intermittent fault the light only comes on when the parking brake is faulty - most of the time the lights out
After correcting the cause of the fault the vehicle must be driven above 40kph to reset the ABS warning light.
The ABS system self tests itself every time you turn on the ignition. If there is a fault the light will illuminate. Repair the fault and the ABS system will test itself and reset the light if everything is good.
To reset the check engine light you must have an OBDII code reader with the reset function. The underlying fault that caused the light to turn on must be fixed or the light will turn on again once the condition is detected. The light will be reset if the battery is disconnected for about 10 minutes but will turn on again if the fault that caused the light to turn on is not fixed. Also, the engine will not run at its best until the computer is retrained.
you have to reset the computer
Try to disconnect the battery for a few minutes.
1: Disconnect battery for 30 mins, reconnect and if fault is fixed light will go out. 2: Once vehicle is fixed, turn ignition on and off 40 times, if fault hasnt been found in 40 starts the light will reset itself.
what is the cause if my engine in my fiat stilo dynamic is knocking .Mainly when i go over 60 mph .
You will need a OBD2 scan tool to reset the light after repairing the problem that caused the fault code. If you do not repair the problem the light will just come back on.
the light can be reset two ways. 1 with a scan tool. 2 if the fault(s) that resulted in the CEL coming on are not present for a given number of drive cycles the light may reset.