Want this question answered?
How can I reset engine light on renault master van 2012 125bhp
To reset the oil change light on a Toyota Highlander 2012, switch the engine to the OFF position. Then switch the engine back on while pressing the trip meter reset button until it displays 000000 or says COMPLETE.
The airbag light stays on when the computer detects a malfunction and sets a code. It cannot be reset until the failure has been repaired.
Passenger side front of the engine, accesses from underneath.
The change oil light is reset by turning the key on, engine off, and pressing the gas pedal three times.The check engine light can only be reset with a scan tool. The cause of the fault needs repaired or the light will return.
Adjust tire pressure and drive it. The light should reset itself after a short drive unless the pressure sensor unit in one of the tires is bad.
The airbag light is on because the airbag module detects a problem with the system. Fix the problem and the light will go out by itself.
Have vehicle scanned at auto parts store to determine problem and repair
Reset - 2012 VI was released on: USA: 1 July 2012 (limited)
After an oil change, the reset light on the 2012 Ford F150 may reset itself. If not, on the left side of the steering wheel use the toggle button to scroll to the settings menu. Press the > button to go to Vehicle Settings. Press > again and scroll to Vehicle. Press > once again and scroll to Oil Life Reset. You can set to any percentage you want from 10-100%. Press and hold the OK button to set.
Key on engine off. Press gas pedal to the floor three times.
Key on engine off. Press the gas pedal to the floor three times.