That is something that a mechanic with a code scanner must do. It is probably set to turn on at a certain mileage to bring attention to certain maintenance that is required by the manufacturer. Service Reset instruction for 2006+ Sprinter (NCV3) with NO steering wheel buttons.
1. Put the key in the ignition and switch it on without starting the engine.
(Wait for LCD to return to the vehicle mileage)
2. Hold the "O" button down till you hear a beep (could take a while, 30 sec.)
3. Press the M button repeatedly and a number of reset menus will appear, (If you have used oil according to quality sheet 229.31 or 228/229.51 you can scroll to Reset.31 or Reset.51 respectively.) Select "reset 51"
4. Now, when appropriate oil type is selected press "O" for 6 seconds until ''2'' is displayed.
5. Press "O" once again briefly and the '' reset done'' message will confirm that the job is done.
6. Pull the Key out (info found on: Sprinter-Source.com)
FOR THE 2004 DODGE SPRINTER!Turn the key to position 2 in the ignition lock and immediately press the button MI (km) twice.Within 10 seconds, return the key to the 0 in the ignition lock.
Press and hold the button MI (km). Turn the key to position 2 in the ignition lock. Keep the button MI (km) pressed.
The maintenance indicator with the time/distance is shown.
After about 10 seconds, an acoustic signal will sound and the maintenance indicator is displayed with the new remaining time / distance .
Release the button MI (km)
hope this helps.
aperantly take the light out
The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$
how to reset manually edc light mercedes benz sprinter 311
There is no reset for the key.There is no reset for the key.
With a scan tool.
What do the REQD light mean on my dashboard of my 1993 Dodge Dakota 3.9L Truck
To reset the maintenance required warning light on a 1989 Dodge Dakota, unhook the battery connector cables for 10 minutes. Reconnect them and start the vehicle.
That requires a scan tool.
There is none.
To reset the maintenance required light on a 1989 Dodge D50, disconnect the battery. Leave it disconnected for 10 minutes before reconnecting it.
Just found out that it must be reset at the dealership with a diagnostic computer
That requires a scan tool.