My mechanic and I found the answer to this one by trial and error. First, pull out the instrument console. It's only a few screws but be careful because you don't have a lot of room to work. On the left side of the console, (in the back) between the speedometer and the edge of the console, you'll find a VERY small switch. Move it to another position (doesn't really matter which one) and the light should go out.
After my 1995 Montero turned 150,000 miles the
Read your owner's manual.
I changed the battery and voila' - no more light.
I need to reset my radio in a 2001 Mitsubishi Montero Sport. I do have the code. But the radio is in OFF mode. I need to get it to CODE mode. Thanks
disconnect the battery for a couple of minutes, if it comes back on after you drive the computer is getting an error code from the engine check the codes to see whats causing it
paps, try 3280 monterosport code for 4x2 glsv 2012 year model or up.﻿
unhook the battery for about 10 min. should reset
To give you the required instructions to reset the maintenance interval the chassi number is required.
maintenance with engine
PLIZ HELP How can i reset the injector maintenance required in lexus gs350 2012
the dealer should of reset it when they did the service. To reset the maintenance required button, insert your key into the slot next to the required maintenance button on the dash and push it in. It will reset the button to "green".
Look at the upper end of the brake pedal under dash area
Are you implying they are all the same? BClear.
After repairing the cause of the code, you clear the code with a scan tool.
The maintenance light,You will need to take it to a Dodge dealer to reset it. Or get a DBR-2 code scanner.BIG $$$
we just call manufacture and gave em vin numbers they gave us the code
How do you reset the maintenance required light in the 2011Toyota RAV4 with a smart key starting system
Since he was asking how to reset it on the ATV outlander not the Mitsubishi outlander, I'll improve the answer. You cannot, you have to take it to the dealer to have them reset it. There are no tricks or aftermarket kits that will reset Can-Am messages. if you do your own maintenance you can wither ignore the light, or show them proof of maintaining it, and take it in to have them reset it.
To reset the maintenance required warning light on a 1989 Dodge Dakota, unhook the battery connector cables for 10 minutes. Reconnect them and start the vehicle.
How do you reset the maintenance light on a 2001 Honda accord ex I found some options at http://www.tegger.com/hondafaq/maintenance-reqd-light.html#why
The maintenance required light requires a scan tool to be reset.
aperantly take the light out
disconnect the battery
With the engine and ignition off push and hold in the odometer reset button. While holding that button in, turn on the ignition but do not start the engine. After about 5 seconds the light will go off and the maintenance required light will have been reset.
disconect the batery cable for 10 minutes, if that don't work take it to the dealer