The abs light is on because there is a problem with the abs system. Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself after a short drive.
reset engine light on 2005 Chevy Colorado 3.5 engine
The service light indicator on a 2004 Chevy Cavalier tells its owners when to send the vehicle in for maintenance. To reset the light, unplug the battery for five seconds.
Pull the positive battery cable off and wait about 10 minutes. This resets all codes in the PCM. But, if you haven't fixed the reason the light came on, the light will only come back on again.
To reset the Passlock system on a 2004 Chevy Colorado, first, insert the key into the ignition and turn it to the "On" position without starting the engine. Leave it in this position for about 10 minutes until the security light turns off. After that, turn the key to the "Off" position for a few seconds, then start the engine. If done correctly, the Passlock system should be reset, allowing the vehicle to start normally.
The Chevy Colorado came out in 2004
To reset the oil change light on a 2004 Chevy Impala, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal three times within five seconds. The light should turn off, indicating that the reset is complete. If it doesn't turn off, repeat the process.
I have a 04 Colorado its easy..... put the key in run and push the GAS IN 3 TIMES and its fixed!!
how do you reset change the oil light in a 2004 alero?
To reset the engine light on a 2004 Chevy Tahoe, you can use an OBD-II scanner to read and clear any trouble codes. Alternatively, you can disconnect the battery by removing the negative terminal for about 15 minutes, then reconnect it. This may reset the engine light, but it’s important to address any underlying issues that caused the light to illuminate in the first place. Always consult a mechanic if you're unsure about the cause of the warning light.
6 3/4" speakers front and rear in a four door 2004 Chevy Colorado.
i have a 2004 Chevy Malibu i nedd to find the reset button please
When you first put the key in the ignition turn it to the on position but do not start it. and pump the gas pedal three times right away. Then wait about 10 seconds, then it should reset