Turn the ignition key to the run position and pump the accelerator 3 times within 5 seconds.
That REQUIRES an ENGINE SCANNER to do that.
when you disconnect your battery and reconnect it will reset cumputer
That requires an OBDII engine scanner.
key on engine off press accelerator pedal to the floor five times very rapidly should reset
engine code reader go to autozone its free tgere
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.
The check engine light comes on to notify the driver that there is an issue. To reset the light, it is best to take care of the issue, or use a scanner that will clear any possible codes.
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
The check engine light does not come on for an oil change.
The check engine light has nothing to due with an oil change.
The service engine soon is the same as a check engine light. It has nothing to do with an oil change.
The check engine light does not come on when an oil change is due. The check engine light is for an emissions related failure. It is reset with a scan tool after the fault is repaired.