Turn the ignition key to the run position and pump the accelerator 3 times within 5 seconds.
To reset the oil change light in a 2011 Chevrolet Silverado, turn the ignition to the "On" position without starting the engine. Press the accelerator pedal fully three times within five seconds. After doing this, the oil change light should reset. Turn the ignition off and then start the engine to ensure the light is no longer illuminated.
To reset the oil change light on a 2015 Chevy Silverado after changing the oil, turn the ignition to the "On" position without starting the engine. Press the gas pedal three times fully within five seconds. Then, turn off the ignition. When you start the engine again, the oil change light should be reset.
That REQUIRES an ENGINE SCANNER to do that.
when you disconnect your battery and reconnect it will reset cumputer
That requires an OBDII engine scanner.
key on engine off press accelerator pedal to the floor five times very rapidly should reset
engine code reader go to autozone its free tgere
Turn the ignition set to on without starting the engine. Press the gas pedal three times in quick succession and watch for battery light to flash three times, when it does, it is reset.
The check engine light comes on to notify the driver that there is an issue. To reset the light, it is best to take care of the issue, or use a scanner that will clear any possible codes.
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
unplug your battery for 15 minutes and it will go off
The check engine light does not come on for an oil change.