The procedure is in the manual. Turn the ignition to the on position, fully depress the accelerator 3 times within 5 seconds, then turn the ignition and start the truck. The light should flash then go off.
www.trailvoy.com All the answers for your Envoy or Trailblazer!
On a 2002 Envoy you turn the key to run but don't start it. Then push and release the gas pedal 3 times within 5 seconds. The change engine oil light should blink for 5 seconds meaning you have reset the system. If it doesn't blink for you do the procedure again.
On a 2002 Envoy you turn the key to run but don't start it. Then push and release the gas pedal 3 times within 5 seconds. The change engine oil light should blink for 5 seconds meaning you have reset the system. If it doesn't blink for you do the procedure again. I'm pretty sure its the same on a 2003. Good luck.
To reset the service engine soon light on a 2004 GMC Envoy you can remove the ECU fuse. ECU stands for electronic control unit.
This light has to be reset by the person doing the oil change. It is not automatic when the oil is changed.
After the oil has been changed, hit your status button. When the oil change comes up hit the reset button.
rest change oil indicator on the dash after you have changed the oil
no you wait till you it changed
The airbag light in the 2003 GMC ENVOY can be reset by disconnecting the battery for about 5 minutes. Then reconnect the battery, turn the key to on without starting the vehicle, and pump the gas pedal three times if the light is still on after reconnecting the battery.
The "change oil light" doesn't run off of the quality/quantity of the oil; it runs off of the odometer and the "memory" of the last time the "change oil light" was reset. In other words, if you changed the oil at 3,500 miles and reset the light at that time, the light will automatically come on at 7,000 miles as a reminder to change the oil. You can reset the light yourself in about 5 seconds. The "change oil light" doesn't run off of the quality/quantity of your oil. It runs off of a pre-determined distance from the last time the light was reset - presumably, the last time the oil was changed. For instance, if you change your oil at 3,500 miles, and the light is set to go off every 3,500 miles, then it will again go off at 7,000 miles, regardless of whether you re-changed the oil. Its just a reminder device. You can also reset the light yourself in about 5 seconds.
The abs light is on because there is a problem with the abs system. The light will remain on until the problem is fixed. Once the problem is fixed the light will reset itself after a short drive.
I believe if you turn on the ignition key (do not crank engine) and depress the gas pedal three times it will reset itself.
Reset the change oil light on Mazda 3