How do you reset the check engine light on 99' Malibu Disconnecting the battery will disable the radio?

NO. has to be cleared with a scan tool

Yes, and disconnecting the battery while the engine is running can severely damage the computers

Temporarily, or ever? Disconnecting the battery would work if you want to do it temporarily. If you want to permanently disable the engine for some reason, drain the oil and replace it with sodium silicate solution, then run the engine until it seizes.

Try disconnecting the battery for about 10 minutes

Try disconnecting the battery.

Either try disconnecting the battery for about 10 mins. or have vehicle scanned to determine the problem On OBD2 disconnecting the battery will do no good as it keeps history codes.jd

Try disconnecting the battery for 1 minute.

try disconnecting the battery that resets your computer

If your engine does not turn off by the key I suggest disconnecting the battery and alternator and immediately fixing what is wrong

Should be able to reset it by disconnecting the negative battery cable from the battery for ten minutes.

you can usually reset those by disconnecting the car battery for 15sec or so.

Just disconnect The Battery. Easy! Disconnecting the battery may or may not work. Know that if you do not repair the problem that set the check engine light in the first place, the light will just come back on. If disconnecting the battery does not reset the light you will have to use an OMB2 scan tool to reset it.

have battery tested bet it is no good

To turn off a service engine light soon on a 1997 Malibu, you will need to unhook the battery for up to 2 minutes. After you hook the battery back up, the light should be off.

I reset the check engine light on my jeep by disconnecting it from the battery.

try disconnecting battery for 15 minutes

Look at the bottom of the engine follow the + battery cable

A person can reset the check engine light by disconnecting the battery. It can also be cleared by using an OBD scanner.

The 2004 Chevy Malibu fuse box is located in the engine compartment. The fuse box will be behind the battery box.

Try disconnecting the battery for a minute or 2 and then re-connect. This sometimes clears the codes in the engine control modules.

Try disconnecting the battery for about 5 or 10 minutes the reconnect, I have heard this works.

The starter on a 85 Cutlass is replaced by disconnecting the battery, unbolting the starter, disconnecting the wires at the starter, and removing it from the vehicle. The new starter is then wired up and bolted to the engine block.

Try disconnecting the battery for 10 minutes to see if it will reset--if not have engine scanned Try disconnecting the battery for 10 minutes to see if it will reset--if not have engine scanned

Unhooking a battery doesn't clear the codes on a 2003 Jeep. You need a scan tool.

The check engine light goes on because there is a problem with the engine control system. Until the problem is fixed it will continue to come back on even after you clear it by disconnecting the battery.