How do you reset the check engine light on a 1999 volkswagen jetta?
The check engine light has to be reset with a OBD scan tool
Check your intake house it may have a whole in it....if it does and your not sure if you want to buy the whole hose......tape it over with electrical tape and see if it work and if it does get a new house....the tape only last for about a couple of house and also the location of the whole to makes it hard to tape.....but that's is what i found out on my jetta
This could be because your anti-theft device is still on. check to see if a light is flashing on the stereo deck. If it is then check to make sure the E-Brake is completely off. The steering wheel will be locked, and you will not be able to start the engine, if the E-brake is on slightly. hope this helps.
The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, a check engine light is lit when there is a problem in the emissions or somthing that is affecting the effectiveness of the emissions. The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle. Generally, a check engine light is…
Also known as CEL (Check Engine Light). Common reason is aloose fuel tank cap,after refueling. Tighen cap, after a few restarts it may autoclear. The same with cylinder misfiring or bad gas. If it persists should have the code cleared (atozone) and find out te eal reason. Google Check Engine light codes for Jetta.
1 Open the fuse panel cover on the driver's side foot well by pulling down on the cover with your fingers. 2 Locate the fuse for the electronic control unit. Use the fuse diagram on the underside of the fuse panel cover to locate the fuse. 3 Pull the fuse using the fuse pullers in the fuse panel. 4 Turn the ignition to the "on" position but do not crank the engine. 5 Wait five…