It is very easy to reset the check engine light on a 2002 Volkswagen Cabrio. The negative battery cable can be taken off for one minute and replaced to reset the light.
The check engine light has to be reset with a OBD scan tool
Timing light. The instructions are on the engine hood.
Yes, especially in Volkswagen cars.
In a 2006 Volkswagen Passat, the transmission fluid symbol warning light is located on the odometer. The yellow light is a representation of the engine with the word check .
After repairing the cause of the code, you clear with a scan tool.
the check engine light goes on and off
To set the ignition timing on a 1997 Volkswagen Cabrio with a 2.0L engine, first, ensure the engine is at operating temperature and then turn it off. Disconnect the timing connector (usually a green wire) to enable the timing to be set at base timing. Use a timing light to check the timing mark on the crankshaft pulley against the timing scale on the engine. Adjust the distributor until the timing mark aligns with the specified timing (typically around 0 degrees BTDC for this engine). Once set, reconnect the timing connector.
Similar thing happened to me. It was the oxygen sensor that went.
The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle.Generally, a check engine light is lit when there is a problem in the emissions or somthing that is affecting the effectiveness of the emissions.The check engine light comes on and stays on when a problem is detected by the self diagnosis system of your vehicle.Generally, a check engine light is lit when there is a problem in the emissions or somthing that is affecting the effectiveness of the emissions.
u need dealership electronic tool to see what's going on and then they clear the codes. check with dealership.
Usually a problem in the emission control system - have vehicle scanned to determine the problem
That is the check engine light.That is the check engine light.