The check engine light normally comes on at certain mileage intervals. For example: when it's time to change the timing belt (96,000km). Under the dash you should be able to locate a plug near the steering column. Beside it there should be another empty connector. Switching over to that empty connector resets the light until the next mileage interval.
To reset the check engine light on a Mazda B2200, you can use an OBD-I scanner to read and clear any stored trouble codes, which will also turn off the light. Alternatively, disconnect the negative battery terminal for about 10-15 minutes, then reconnect it, which can also reset the light. However, ensure that any underlying issues causing the check engine light to activate are addressed to prevent it from reappearing. Always consult your vehicle's manual for specific instructions related to your model.
I'm guessing that you are wanting to know how to get the Check Engine Light to go off. It would be a VERY good Idea to have a qualified shop hook it up and find out WHY it is on and then Fix the problem that your On-board Computer is detecting. Hoipe This Helps.
The check engine light on a Mazda Tribute gives warning of potential problems. It can signal overheating, low oil, or engine misfires.
how to reset check engine light on 1992 Mazda mpv
If the check engine light is blinking , an engine cylinder misfire has been detected
Look on the drivers side under the dash on the left hand side and you will see three wires two are connected just switch two of the wires and the light will go off.
A flashing check engine light means an engine cylinder misfire has been detected
I'm not sure but you may need to check the engine.
When the check engine light comes on, it's a good indication that something is wrong with your engine.
ODO
There is no dedicated fuse for the light.
The "check engine light" on a Mazda three is located to the left lower side of the tachometer. It is orange in colour.