0
What else can I help you with?
What happens when an oxygen sensor goes out on a mazda b2500 1998 model?
It will cause your check engine light to come on and usually you will start getting really crappy gas mileage.
What does the 2004 Mazda 3 engine warning light look like?
The "check engine light" on a Mazda three is located to the left lower side of the tachometer. It is orange in colour.
Where is the Speedsensor On A 1999 Mazda b2500?
I replaced one on my 2000 Mazda b2500. it's located on top of the differential. You un hook the one wire harness, remove one bolt and pry it out with a screw driver. It's not in there too tight, comes out pretty easy. It fixed my speedometer, ABS light and check engine light. I had to use a mirror fixed above the differential and a flash light to see what I was working on. Or you can just feel for it. You can get the part from autowarehouse.com for about $18, great place for parts. Now mine is a 2000 yr. I don't know if the 1999 would be the same or not. Good luck. By the way, dose anyone know the difficulty factor on changing the spark plugs on this 2000 Mazda b2500 4 cylinder engine? It doesn't look like fun to me.
Mazda MPV 1992 How do you read diagnostic codes lamp Check engine is ON?
how to reset check engine light on 1992 Mazda mpv
Check engine light Mazda Tribute?
The check engine light on a Mazda Tribute gives warning of potential problems. It can signal overheating, low oil, or engine misfires.
Where is the bleed nipple for the clutch slave cylinder on a 98 Mazda b2500?
The bleed nipple for the clutch slave cylinder on a 1998 Mazda B2500 is located on the slave cylinder itself, which is mounted on the transmission. To access it, you may need to lift the vehicle and remove any obstructions. The nipple typically points upward, allowing for easy attachment of a bleed hose when performing a hydraulic fluid bleed. Be sure to check the specific orientation and accessibility for your vehicle model.
How do you put freon in your Mazda b2500 truck?
To add Freon (refrigerant) to your Mazda B2500 truck, first locate the low-pressure service port, usually found on the larger diameter A/C line. Attach the refrigerant canister to the port with the engine running and A/C set to maximum. Open the valve on the canister slowly while monitoring the pressure gauge, ensuring it stays within the recommended range. After adding the refrigerant, disconnect the canister and check for any leaks.
Where is the transmission dipstick located on a 1998 Mazda Millenia?
2 9s here, if it is a 2.5 the trans dip stick is located to the right of the air intake hose, between the battery and hose. to check fluid when engine is cold leave engine off and check level. if the engine is warm have it running while you check the level.
Why is the check engine light on on a 1991 Mazda 626?
I'm not sure but you may need to check the engine.
Why does a check engine light blink on a 1998 Mazda 626?
If the check engine light is blinking , an engine cylinder misfire has been detected
Why is your check engine light flashing on your 1999 Mazda millenia?
A flashing check engine light means an engine cylinder misfire has been detected
What is engine check code 332 for 1994 Mazda 626?
A check engine code 332 for a 1994 Mazda 626 means that the EGR valve's voltage is lower than it is expected to be. The ERG valve is part of your Mazda's emission control system.
