Disconnect the negative battery cable for about two minutes and that should reset your check engine light.
dealer must clear
The best way to reset the engine warning light on a Nissan Primera p12 would be to take it to a mechanic. It is best to have a mechanic check it out to make sure nothing is wrong that could malfunction and put someone in danger. The mechanic will be able to reset the engine warning light.
A person can rest the check engine light on a Jeep Wrangler by disconnecting the battery. This will also rest other warning lights on the dash.
The check engine and other dash warning lights can be reset by disconnecting the vehicles battery for more then 5 minutes. If warning light continues after reconnecting battery then there is still a problem.
Try to reset any engine warning lights after the situtation if resolved by disconnecting the positive post of the battery for at least 30 minutes. This gets the computer time to possibily reset and eliminate the warning light.
after the cause of the code is repaired, you reset with a scan tool, or by unhooking the battery.
The only proper way is with a scan tool.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
How do you reset the check VSC system warning on Lexus ls460 l 2007
need to reset the computer go to auto zone and they will usually do this for free but just tell them you have a check engine light on
Disconnect the battery for about five minutes and that should reset the check engine light. Or, pull the 80 amp fuses in the small plastic compartment on top of the battery for about the same time.
you have to hook up a scaner and press code reset or a auto zone store will do it for you
how do you reset the tire pressure warning light on a 2004 pontiac grand prix
You reset the check engine light with a scan tool after repairing the failure.
try disconnecting battery for 15 minutes
go to advance and let them shut it off
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
I disconnected the battery and left doors open. I was thinking it would drain the capacitors. I left it for about 30 minutes. The check engine light was off and the warning on the dash disappeared.
How to reset service light on a 2004 grand am
What warning light? The only warning lights that can be reset are the Maintenance Required and Check Engine Light. The Maintenance Required light is reset in different ways depending on model and year. The procedure is listed in your owner's manual. Reset the light after performing scheduled maintenance listed in your owner's manual, usually oil/filter change. The Check Engine light is reset by repairing the problem then unhooking the battery for 15 minutes, on a pre-1996 vehicle. On a 1996 and later vehicle it normally requires you use an OBD2 scan tool to reset the light. If you do not repair the problem that set the fault code, the light will just come back on. Your oil pressure warning light means you have low oil pressure, temp warning light means the engine is over heating, alternator light means the charging system has a problem.
how do i reset the check engine light on a 1999 acura 3.2tl
on most vehicles if you disconnect the battery cables it will reset the check engine light
hoe do you reset the check engine light in a 1995 land rover