After there has been a break in the in the power to the automobile there are three settings that need to be reset. The clock must be reset according to the instructions in the owner's manual. The ESP must be reset. This is done by starting the car and turning the steering wheel to the steering lock position on either side. Turn the steering wheel to the left or right until it cannot be turned further and then turn it in the opposite direction until it cannot be turned further. Confirmation that the ESP has been reset will be the ESP light on the dashboard going out. The radio must be reset. When you turn the radio on the display will read CODE and prompt you to enter your radio code. If you are fortunate enough to have the code enter it and press the button under the OK display. If you do not have the code or the code you have doesn't work you will need to call Mercedes Benz Customer service with the VIN number of the vehicle and probably confirm in some way you are the owner. They will give you the radio code they have on record. Enter that five digit number and press the button directly under the OK display to get the radio to accept the code. If the radio comes on it worked. If it didn't try getting the code from the nearest dealership.
do you have to reset computer after changing battery in 2003 745li
You do not have to reset the computer.
There is nothing concerning the computer that needs to be reset.
No, you do not have to reset the computer. It will take care of itself.
Not necessary. The computer will reset itself after a few driving cycles.
the computer needs a reset
You do not have to reset anything. but you should have the battery disconnected. and once you reconnect the battery it will reset your computer.
No.
Yes, you do... But if you do within 1-2 minutes you might not reset the computer.
You do not have to reset the computer any more than you reset your computer in your home after a power outage. It will take care of itself.
You do not have to reset the computer after this repair. If the Check Engine Light is on it is not because you made this repair. If you disconnected the battery the computer will reset itself.
try unhooking battery cables and then rehooking them up, most of the time that will reset the computer if not you may need a new computer for it, and they are not cheap!!!!