0
What else can I help you with?
Why is message center flashing after changing battery on 2004 Monte Carlo ss?
Drive it for a few miles and see if it goes out, sometimes the computer has to reset itself.
How do you reset the computer on a 2004 Mercury Mountaineer?
Disconnect the negative side of the battery
How do I reset the computer on a 2004 Sunfire?
Disconnect the negative battery cable for 20 minutes.
How do you reset the computer on a 2004 Chrysler Sebring?
You can use a scan tool or unhook the battery.
Can you reset the computer on a 2004 pacifica by unplugging the battery?
You can not. I just did that about 5 min ago and nothing changed.
How do you reset the computer on a 2004 Chrysler Town and Country?
You can either unhook the battery for 5 minutes or use a scan tool.
How do you reset the check engine light on a 2004 Ford Taurus?
Remove one of the battery post cabes from the battery for 5 munutes. Now learn how to retrain the computer because it is reset and upset also at this time.
How do you reset check engine light after replacing O2 sensor on 2004 pt cruiser?
Just unplug the negative terminal of the battery for about 10 minutes and that will reset the computer
How do I reset the computer in my 2004 range rover?
disconnnect battery termials, wait 10 minutes, touch the terminals together, reconnect
How do you reset service engine light on a 2004 impala?
Disconnect the red terminal on battery and let it sit for 15-30 minutes, reconnect the battery and check engine light should be off because the computer has been reset.
How do you reset computer on jeep liberty renegade 2004?
With a scan tool, or unhook the battery for 5 minutes.With a scan tool, or unhook the battery for 5 minutes.
How do you reset computer on a 2004 Jeep liberty?
To reset the computer on a 2004 Jeep Liberty, you can disconnect the negative battery cable and leave it disconnected for about 15 minutes. This allows the computer to reset and clears any stored error codes. After the time has passed, reconnect the negative cable and start the vehicle, allowing it to idle for a few minutes to help the computer recalibrate. Alternatively, you can use an OBD-II scanner to clear codes directly from the vehicle's computer.
