answersLogoWhite

Be the first to answer!

Who doesn't love being #1?

Be the first to answer this question.

Related Questions



The 1990 Stanza only came with a 4 sylinder.


My 1990 Stanza has the fuse listing inside the cover of the fuse box.


1990 Nissan/Datsun Stanza 2.4L FI 4cylThe Spark Plug Gap.044 (In thousandths of an inch)



Look at the lower rear end of the engine


Just underneath the alternator on the 2.4


it has an effect if you dont change the fuel injected


Mounted on top and inside the fuel pump.


5/30 will get in between the tight moving parts


the inhibitor relay is between the a/c relay and the cornering relay


The 1990 Mitsubishi does have a computer. You can reset the computer by removing the positive cable from the battery. Keep the cable off for 30 seconds and return it to its original position.


This vehicle do not have a transmission filter. All you have to do is drain the trans. fluid and refill.


Clockwise, watch the distributor and you can confirm this. Look at the firing order and you can reconfirm this


The 1990 Stanza could have damage, depending on which engine is in the vehicle. Check to see which engine you have, and if it is listed as an interference engine. If it is the interference type, then the valves are probably bent and destroyed.


Attached to body behing brake pedal (if automatic) clutch pedal (if standard)


well we have a 91 stanza and ours is located under the glovebox dash u have to take everything off to get it out try checking there good luck


you can see the valve on the fuel injector. it is on the passenger side of the car and to the front of the injector.


You should [http://www.themotorbookstore.com/index.html Purchase a manual] or take it to a transmission shop if you are not sure on how to do it.


A car made in the early 1990's would be lucky to sell for a thousand dollars.


There is no OBD connection on a 1990 Nissan as that is an OBD1 vehicle not OBD2. However there is a way to read the codes. https://codes.rennacs.com/Petrol-Engine/Japanese-Korean/Nissan-Engines.php


There is no problem with the fit. The computer has a different conector but can be made to work.


behind the panel next to your gas pedal


If it is a standard shift, find the wire from the speed sensor that is going to the computer and cut it :) or put a diode in it causing it to only have half the pulses. Will run all out then.Most cars are limited around 100 mph.


A 1990 Jeep Cherokee does not have a reset switch. The fuel system is computer controlled. If not functioning properly there could be a fuse or sensor malfunction.



Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.