you can reset your computer and it will turn off the check enigne light by simply removing the negative cable from your battery for 10 seconds and then hooking it back up, when you start your car the light should go off within seconds, if their is a problem with your emission controls that is making the light come on to begin with it will come back on again, if it is just the computer telling the light to come on so you will take it in to the dealer then un hooking the negative cable will reset the computer which will reset the light, ya out,!
To reset the check engine light on a 1998 Honda Civic located the blue 15 amp fuse in the engine bay fuse box. The fuse is labeled ECU, and will reset the check engine light when removed.
I reset the check engine light on my jeep by disconnecting it from the battery.
its in behind the glove box to the right theres a button
Disconnect the negative battery cable for five minutes. But, unless you repair the problem that set the light in the first place it will just come back on.
A quick way to reset the check engine light would be to disconnect the battery for a short while
disconnect the battery for 1 minute and it will reset.
You can reset the check engine light, on your 1998 Land Rover, by repairing what ever is causing the light to stay on. You can determine the cause by using a diagnostic tester.
After repairing the cause of the code, you reset it with a scan tool.
Battery disconnect or a scan tool.
With an OBD2 code reader
Disconnect the battery cable, wait few second that reconnect. That will reset the engine light but doesn't fix the problem. if the problem was not fixed the light will come back on.
Have vehicle scanned to determine the problem