To reset the check engine light unplug the battery for 30 minutes. If the issues still persists the light will still light up when reattached.
Disconnect the negative battery terminal for at least 30 seconds.
if you are looking to reset a check engine light or any trouble codes, you will need to have it done with an OBD2 handheld scanner.
How do I reset the service engine light on a 2003 Chevy Trailblazer?
How do you reset check engine light for the 2009 Chevy trail blazer?
Time with no problems will make the light go out or you can hit the reset button on the test unit. If you have an auto parts store nearby, they will very often do this for you.
Leave the key on for about 15 min.
The instructions on how to reset the brake maintenance light in a Chevrolet Malibu can be found in the owner manual. It can be viewed for free at Chevrolet's official website.
You can either bring it in to a Chevy dealer or use a programmer/tuner to reset the check engine light.
You have to reset the oil life in the computer to get it to go out.
How can I myself reset the airbag light to my chev malibu 2003. The light just started to stay on and now it wont go off. If i can't fixed it how much should i pay to get it fixed..bob
I reset the check engine light on my jeep by disconnecting it from the battery.
It requires an engine scanner to do that.
disconnect the battery for five minutes, It will reset
That REQUIRES an ENGINE SCANNER to do that.
disconnect the battery for 1 minute and it will reset.
The engine light on a Chevy Colorado can be rest by connecting an OBD II reader to the interface port under the dash. Each code can then be reset which will disable the dash light until the error is detected again.
i have a 2004 Chevy Malibu i nedd to find the reset button please
With engine off. Turn key to on. Press accelerator fully three times. This should reset light.
That requires an OBDII engine scanner.
Use an OBD scan tool to reset or disconnect the battery
Fix the cause of the light coming on and the light will reset itself within a few drive cycles.
NO. has to be cleared with a scan tool