Type your answer here...
You need to start a drive cycle as follow, cold start idle 3 minutes,
drive 10 miles at 65 mph if possible cruise on, exit the freeway and stop idle 3 minutes, and do some city driving with normal stop and go traffic.
recheck monitors,
These are the options for code 31. You need to have it checked with a scanner, If you know the "P" number you will know what to check. The old two digit codes are not specific enough. EVAP LEAK MONITOR LARGE LEAK DETECTED p0455 EVAP LEAK MONITOR PINCHED HOSE FOUND p1486 EVAP LEAK MONITOR SMALL LEAK DETECTED p0442 EVAP PURGE FLOW MONITOR FAILURE p0441. EVAP PURGE SOLENOID CIRCUIT p0443
u need to drop the spare tire !! and there it is !!
in the back on the drivers side
The evap cannister is located underneath the vehicle in front of the fuel tank.
Is this reachable at home for chevy 98 camaro Evap purge solenoid
Small leak in the evap system. You need to do a smoke test
Its in the back of the suburban has a 2 wire connector and a air hose attached to it next to a box with two air hoses going to it
by the tank or evap canister
To the fuel tank
Trouble code P0441 means: EVAP Purge Flow Monitor Fault
Where is evap canister located on a 1996 chevy s10 blazer? It should be found above the rear axle on the drivers side, mounted to the inside of the frame rail.
Above the spare tire.