answersLogoWhite
Fuel Pumps
Chevy Silverado
Mercury Grand Marquis

How do you reset the fuel pump switch on a 1994 grand marquis?

232425

Top Answer
User Avatar
Wiki User
2006-02-13 11:31:01
2006-02-13 11:31:01

If it is anything like the 1993 model, open the trunk on the drivers side near the trunk lid hinge pull the carpet back, you should see a box with a red button on it push it in to reset the fuel pump.

1

Related Questions

User Avatar

There should be a roll switch right next to your light switch on your dash to dim the lights with.

User Avatar

i have no heat in my 1994 mercury grand marquis. what could cause the heat to stop working

User Avatar

Fuse, loose connection, or the light switch. how do you remove the dashboard on a 94 mercury grand marque?

User Avatar

.054 is the gap for the Mercury Grand Marquis.

User Avatar

How do you replace the timing chain on a 1994 mercury grand marquis

User Avatar

There should be an EEC TEST connection in the engine compartment ( a 1994 Mercury Grand Marquis is OBD I , EEC-IV )

User Avatar

A 1994 Mercury Grand Marquis has the 4.6 liter / 281 cubic inch Single Over Head Cam ( SOHC ) V8 engine from the factory

User Avatar

In a 1994 Mercury Grand Marquis : It came from the factory with the 4.6 liter / 281 cubic inch , Single Over Head Cam ( SOHC ) V8 engine

User Avatar

Probably the turn signals , hazard flashers , high beam headlights etc. like it does on my 1995 Ford Explorer

User Avatar

A 1994 Grand Marquis came from the factory with 190 horsepower (if equipped with only a single exhaust setup) or 210 (if equipped with a dual exhaust setup).

User Avatar

Where is the fuel pump relay switch located on a 1994 Grand Am SE

User Avatar

yes it will i have a optima battery in my 1995 marquis

User Avatar

GM cars do not have inertia/reset switches.

User Avatar

Put the key in the driver's door (from the outside), and unlock the door. That resets the security system.

User Avatar

Buick didn't make a Rainier in 1994

User Avatar

The fuel pump reset switch in a 1994 Volvo 940 is located under the hood. The relay will be in the fuse box.

User Avatar

Could be the tires, or your front brake rotors

User Avatar

Jeep doesnt use inertia/reset switches.

User Avatar

Jeep doesn't use an inertia/ reset switch. The fuel system is computer controlled with relays.

User Avatar

There is a switch on the right side of the steering column that turns the O/D on and off. Make sure you have O/D enabled via this switch, as it's very possible that it is turned off.

User Avatar

Your Brake Lights. It's mounted on the Steering Column and is very easy to change. Around $10 at your local parts store.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.